Bathroom - forming their own hands

One of the best decorative elements can also be installed in the bathroom, is the custom molding. Many people - it - yourselfers will avoid a project like this because they believe that it requires too many skills or experience. Rather than simply the home page, install molding, and reached only on anyone.

The selection is the first Commissioner to overcome. Can be super-easy, perhaps too easily. Some people may simply choose what play it. But the result will be disappointing. Need some time to explore options. Envisaged the final outcome, and how to integrate with the overall design.

A typical Greece, for example, would be very suitable for brass and marble floors and water installations. However, it will lose in a colonial setting. A dark British gentleman's club style shape, will conflict with the bathroom decorated in pastels and perfume bottles.

Once you have the right style, the project is straightforward. It just requires patience and careful construction.

Forming be able to order pre-cut to the appropriate length, complete with the corner of the cut. But few will have sufficient accurate results. Reason is that the layoffs will be good to adapt to work together, that is to say, 45 ° angle.

However, the construction of small bathrooms, so it is. Will be forming units to the wall and there is a gap between the joint, or joint, will be perfect, but works will depart from the wall. Let them of their rights, for your bathroom about - cutting the scene, usually require. But it more vulnerable to a reduction of one unit than the one before cutting a shaving, especially if it is cut before dyeing.

Carefully assess the corner, where your bathroom, you will be forming. Not all are 90 °. Do not think that the walls come together, at the same point of view, as at the floor, the ceiling. It will be close, but not accurate.

Corner, can be reduced, precisely to your needs and complex characters to see. If you do not own one, you can mark the entries to your exact specifications, and then take them to the local Home Depot and their reduction. It is always better to cut too little rather than too much. You can shave a small amount of sand or during the installation.

Permission for the fact that the wall is not always completely flat. Some adjustments will need to walls or spoon bow slightly. Can be handled carefully shave the back of molding. But it easier to use, some flexible materials and the use of glue or a series of small nails into the exact shape to press the right position, along the wall.

Once everything is cut and shape Qiaqia Hao, the rest is easy. Nail the molding to the local, with small finishing nails long enough penetration forming and about 1 / 4 inch of the wall. In some spots, you may want to use wood putty or some type of liquid nail glue, in order to get a precise fit.

Then paint or stain to match the look you want. It is possible to pre-paint or stain, but hammering and shaving often require some touching up. On the other hand, staining or painting in place, requires great care. This is the best depends on your personal skills and brush and hammer.